中文  |   English

联系我们

电话:0312-3013660

传真:0312-3013660

手机:18233233061

行业新闻
射芯机制造加工的注意事项
1、必须穿戴好防护眼镜等防护用品。
1, must wear protective glasses and other protective equipment.
2、检查射芯机及通风装置,确保正常完好。
2, check core shooting machine and ventilation device to ensure normal and intact.
3、检查芯盒、射砂板、射砂头、射砂筒、闸门板等工装设施,确保光洁完好,相互之间装配要牢固可靠。
3, check the core box, sand blasting board, shooting sand head, shooting sand cylinder, gate plate and other tooling facilities to ensure smooth and complete, and the assembly must be solid and reliable.
4、合闸通电加热前,要开启水冷射砂板水源,同时检查加热装置及有关电气设施,确保安全可靠。
4. Before switching on and heating, it is necessary to turn on the water cooling sand board, and check the heating device and electrical facilities to ensure safety and reliability.
5、开车前,开启通风装置,同时放储气包内积水,然后打开气源,空载试车,确信动作正常方可使用。
5. Before starting the car, turn on the ventilation device and put the water in the gas bag, then open the gas source and carry out the trial run without any load.
6、操作时,严禁手触芯盒,以防烫伤,夹伤手指。
6. During operation, it is forbidden to touch the core box with hands to prevent scalding and injure fingers.
7、必须保证射砂筒有足够的芯砂(一般不少于2/3射砂筒容积)方可射砂,严禁无砂空射。
7, we must ensure that there is enough core sand (usually not less than 2 / 3 shot sand tank volume) to shoot sand, and no sand and air shooting is strictly prohibited.
8、射砂时,操作人应避开分盒面分盒,以防分盒面密封不良喷砂伤人。
8. When shooting sand, the operator should avoid the sub box surface to separate the box, so as to prevent the poor sealing of the box surface and sandblast.
9、从芯盒中拿取砂芯及对射砂板扎通砂孔时,必须戴好手套,以防烫伤手。从芯盒取出的砂芯要堆放整齐,防止倒塌。
9. When you take sand core from the core box and sand holes through the sand board, you must wear gloves to prevent scalding. The sand cores removed from the core box should be stacked up to prevent collapse.
10、工作完毕,要及时清理射砂筒,射砂头和砂斗内残砂,清理芯盒和射芯机的结砂,清理工作场地,确保工作场地整洁。
10, after the work is finished, we should clean the sand barrel in time, shoot the sand head and sand in the sand bucket, clean the sand of the core box and the core shooting machine, clean the work site, and ensure the clean work site.

  1. 电话:0312-3013660
  2. 传真:0312-3013660
  3. 手机:18233233061
  4. 备案号:冀ICP备18002375号

版权 © 保定市乐通机械设备科技有限公司  推荐:垂直造型线,静压造型线,自动浇注机,半自动浇注机  网站制作:保定遨游公司