自动造型机的安装调试注意事项
Precautions for installation and debugging of automatic molding machines
1、自动造型机到达客户现场首先确认外观有无破损，是否因运输或吊运对造型机造成损伤；
1. When the automatic molding machine arrives at the customer's site, first confirm whether there is any damage to the appearance and whether it has been damaged due to transportation or lifting;
2、确认造型机底座与基础接触牢固，设备调平，底座不得有悬空；
2. Confirm that the base of the molding machine is firmly in contact with the foundation, the equipment is leveled, and the base must not be suspended;
3、中箱行走框行走平稳，无明显晃动、无干涉。合箱无缝隙、无倾斜，脱模无倾斜（四个滚轮与导轨同时接触且模板水平），无干涉（四个滚轮边沿不与导轨接触）；
3. The traveling frame of the middle box moves smoothly, without obvious shaking or interference. There is no gap or inclination when closing the box, and there is no inclination when demolding (four rollers are in contact with the guide rail at the same time and the template is horizontal), and there is no interference (the edges of the four rollers are not in contact with the guide rail);
4、手动所有单个动作均正常后可进行一键合箱，一键复位动作，所有接近开关、磁性开关位置准确，无松动。一键合箱保证射砂口与砂箱入砂口对齐（上下箱各一处）；
4. After all individual manual actions are normal, one key box closing and one key reset actions can be performed. All proximity switches and magnetic switches are accurately positioned without looseness. One click box ensures that the sand injection port is aligned with the sand inlet of the sand box (one on each upper and lower box);
5、润滑泵设置完成检查是否正常工作；
5. Check if the lubrication pump is functioning properly after setting up;
6、上箱加热设置完成检查是否正常工作；
6. Check if the heating setting of the upper box is completed and whether it is working properly;
7、空调设置完成检查是否正常工作；
7. Check if the air conditioning is functioning properly after setting up;
8、造型试验观察密封圈是否密封、料位计是否准确；
8. Conduct modeling tests to observe whether the sealing ring is sealed and whether the material level gauge is accurate;
9、造型试型完成检家庄电动伸缩门 保定桌椅  保定水处理设备 河北机械加工 北京电动门  保定养老院  保定防水查所有螺栓、螺母是否有松动，进行紧固，同时检查线路接头、及管路是否松动，进行紧固；
9. After completing the design trial, check if all bolts and nuts are loose and tighten them. At the same time, check if the line joints and pipelines are loose and tighten them;
10、自动造型机调试完成，固定造型机。
10. Automatic molding machine debugging completed, fixed molding machine.